Rear Safety Belt Retractor - Vehicles With: Convertible Top: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install the safety belt assembly.
- Install a new Torx bolt and tighten to 45 Nm (33 lb.ft).
- Position the safety belt through the rear seat backrest trim panel.
- Secure the safety belt.
- Attach the safety belt lower anchor, install a new nut and tighten to 30 Nm (22 lb.ft).
- Install the rear safety belt trim panel.
- Secure with the clips.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Install the rear seat backrest trim panel.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Install the clips.
- Install the rear seat backrest. Refer to Rear Seat Backrest information.
- Close the convertible top.
- Depress the switch.