LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Safety Belt System) >> Safety Belt System >> Removal And Installation >> Front Safety Belt Retractor >> Installation

Front Safety Belt Retractor: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the safety belt retractor assembly.
    • Install a new Torx bolt and tighten to 45 Nm (33 lb.ft).
    • Connect the electrical connector.
  2. Install the rear quarter trim panel. Refer to Rear Quarter Trim Panel - 2-Door and Rear Quarter Trim Panel - Vehicles With: Convertible Top information.
scientia non olet · About LEMON Manuals