LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Rear Drive HALFSHAFTS) >> Rear Drive HALFSHAFTS >> Removal And Installation >> Outer Constant Velocity (CV) Joint Boot >> Installation

Outer Constant Velocity (CV) Joint Boot: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the components for deterioration.
    2. NOTE: Align to the position noted on removal.
  2. Install the CV joint boot.
    • Secure the clip.
  3. Install the circlip.
    4. NOTE: Check that the circlip is fully engaged.
  4. Install the outer CV joint.
    5. CAUTION: Only use lubricants meeting the Jaguar specification.
  5. Pack the CV joint with the grease supplied.
    6. CAUTION: Ensure enough air is present in the CV boot before the retaining clip is secured.
  6. Install the CV joint boot to the CV joint.
    • Secure the clip.
  7. Install the halfshaft. Refer to Halfshaft . .
scientia non olet · About LEMON Manuals