LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Rear Drive Axle/Differential) >> Rear Drive Axle/Differential >> Removal And Installation >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pinion Seal Replacer (204-264)
    GJ0024907
  2. See figure
    GJ0024906
  3. Adapter for 204-265 (204-267)

    Adapter for 204-265 (204-266)

    Remover/Installer, Drive Pinion Seal (204-265)

    GJ0024908
    4. CAUTION: Make sure the drive pinion flange has no end float and is free to rotate.
    CAUTION: Make sure that the drive pinion flange scribed mark is aligned and is never tightend short of the scribed mark on the drive pinion shaft and is no more than a maximum of 5 degrees past the scribed mark on the drive pinion shaft.
    NOTE: Using the special tool, counter hold the drive pinion flange.
    NOTE: Measure the depth of the pinion nut on the pinion shaft to previous noted depth.
  4. Retainer, Drive Flange (205-053)

    Adapter, Drive Pinion Flange (205-053-03)

    GJ0024904
  5. Check and top-up the differential case.

    Torque: 34 Nm

    GJ0022993
  6. Refer to Driveshaft - TD4 2.2L Diesel information. Refer to Driveshaft - V6 3.0L Petrol information. Refer to Driveshaft - V8 5.0L Petrol/V8 S/C 5.0L Petrol information. Refer to Driveshaft - TDV6 3.0L Diesel information.
scientia non olet · About LEMON Manuals