Differential Case: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

NOTE: Make sure that the alignment mark on the driveshaft is correctly aligned to the alignment mark on the differential case.

To install, reverse the removal procedure.

NOTE: This step only applies if a new driveshaft is being installed.

NOTE: Using the 3mm hole on the differential case flange and paint alignment mark on the driveshaft (as indicated). Make sure that the alignment marks are correctly aligned.

Torque: 75 Nm
Check and top-up the differential case.
Torque: 34 Nm

Vehicles with supercharger

See figure