LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Rear Drive Axle/Differential) >> Rear Drive Axle/Differential >> Diagnostic Procedures >> Rear Drive Axle And Differential >> DTC Index

DTC Index

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00
NOTE: If the control module is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module.
NOTE: Generic scan tools may not read the codes listed, or may read only five digit codes. Match the five digits from the scan tool to the first five digits of the seven digit code listed to identify the fault (the last two digits give extra information read by the manufacturer-approved diagnostic system).
NOTE: When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places and with a current calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.
NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
NOTE: If the Rear Differential Control Module, Rear Differential Actuator or the Rear Differential are replaced the on demand self test (ODST) must be carried out to calibrate the components.
DTC Description Possible Cause Action
P0562-00 System Voltage Low - no sub type information
  • System voltage low at ECU (supply voltage less than 9 volts)
Refer to the electrical circuit diagrams and check, power and ground circuit for fault
P0563-00 System Voltage High - no sub type information
  • System voltage high (supply voltage supply greater than 16 volts)
Check Engine control module for stored DTCs, Suspect charging system fault. Refer to the electrical circuit diagrams and check, power and ground circuit for fault
P0604-00 Internal Control Module Random Access Memory (RAM) Error - no sub type information
  • Module internal fault
Suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0605-00 Internal Control Module Read Only Memory (ROM) Error - no sub type information
  • Module internal fault
Suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0606-00 Control Module Processor - no sub type information
  • Module internal fault
Suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0607-00 Control Module Performance - no sub type information
  • Module internal fault
Clear DTCs, cycle ignition if DTC returns suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0652-00 Sensor Reference Voltage B Circuit Low - no sub type information
  • Motor position sensor supply below 5.7 V
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Position Sensor Circuit for fault. If circuit is correct suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0653-00 Sensor Reference Voltage B Circuit High - no sub type information
  • Motor position sensor supply above 8.3 V - Internal control module failure
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Position Sensor circuit for fault. If wiring integrity is correct suspect the Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0666-00 PCM / ECM / TCM Internal Temperature Sensor A Circuit - no sub type information
  • Internal ECU temperature sensor value above 105 Degrees C
Investigate security of Rear Differential Control Module fixings. The units heatsink is through its mounting, if fixings secure, suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0712-00 Transmission Fluid Temperature Sensor A Circuit Low - no sub type information
  • Rear Differential Actuator - Motor Temperature Sensor open circuit or short circuit to ground
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Temperature Sensor circuit for open circuit or short to ground
P0713-00 Transmission Fluid Temperature Sensor A Circuit High - no sub type information
  • Rear Differential Actuator - Motor Temperature Sensor short circuit to power
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Temperature Sensor circuit for short circuit to power or motor circuit. Repair short circuit. Clear DTCs, cycle ignition. If DTC returns suspect the Rear Differential Actuator, refer to the new module / component installation note at the top of the DTC Index
P0806-00 Clutch Position Sensor Circuit Range/Performance - no sub type information
  • Mismatch of actual and expected/calculated actuator position
Clear DTCs. Cycle ignition, Carry out on demand self test (ODST), record DTCs. Clear DTCs. Cycle ignition. Road test. If DTC reoccurs suspect mechanical fault with Rear Differential, refer to the new component installation note at the top of the DTC Index
P0807-00 Clutch Position Sensor Circuit Low - no sub type information
  • Open circuit or short to ground of DC Motor Position Sensor signal A or B
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Position Hall Sensor signal circuit (A or B) open circuit or short to ground
P0808-00 Clutch Position Sensor Circuit High - no sub type information
  • Short circuit to power supply of DC Motor Position Sensor signal A or B
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Motor Position Hall Sensor signal circuit (A or B) short to power or motor circuit
P080A-00 Clutch Position Not Learned - no sub type information
  • On demand self test (ODST) Re-calibration failed. RDCM runs with default values
Clear DTCs. Cycle ignition, Carry out on demand self test (ODST), record DTCs. Clear DTCs. Cycle ignition. Road test. If DTC reoccurs suspect mechanical fault with Rear Differential, refer to the new component installation note at the top of the DTC Index
P0894-00 Transmission Component Slipping - no sub type information
  • Internal Magnetic Brake of Actuator is slipping
Suspect Rear Differential Actuator, refer to the new component installation note at the top of the DTC Index. Replace Rear Differential Actuator, Clear DTCs. Cycle ignition, Carry out on demand self test (ODST), record DTCs. Clear DTCs. Cycle ignition. Road test.
P0900-00 Clutch Actuator Circuit / Open - no sub type information
  • Open circuit of DC Motor power supply circuit
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Clutch Actuation Motor circuit for open circuit
P0901-00 Clutch Actuator Circuit Range/Performance - no sub type information
  • Both DC Motor supply leads are short circuited against each other or H-bridge overload detected
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Clutch Actuation Motor circuit for circuit fault
P0902-00 Clutch Actuator Circuit Low - no sub type information
  • Short circuit to ground of Motor supply cable
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Clutch Actuation Motor circuit for circuit short to ground
P0903-00 Clutch Actuator Circuit High - no sub type information
  • Short circuit to power of Motor supply cable
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Clutch Actuation Motor circuit for circuit short to power
P1603-00 EEPROM Malfunction - no sub type information
  • Module internal fault - EEPROM failure detected
Suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P1783-00 Transmission Overtemperature Condition - no sub type information
  • Rear Differential Oil Temperature Sensor value above 160 Degrees C
Clear DTCs. Allow vehicle to cool, read DTCs if DTC reoccurs suspect Rear Differential Actuator - Motor Temperature Sensor fault
P186A-00 Differential Lock-up Actuator Brake Control Circuit / Open - no sub type information
  • Open circuit of DC Motor Brake supply circuit
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Brake Solenoid Circuit for open circuit
P186B-00 Differential Lock-up Actuator Brake Control Circuit Low - no sub type information
  • Short circuit to ground of DC Motor Brake supply circuit
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Brake Solenoid circuit for short to ground
P186C-00 Differential Lock-up Actuator Brake Control Circuit High - no sub type information
  • Short circuit to power of DC Motor Brake supply circuit
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Brake Solenoid circuit for short to power or motor circuit
P186D-00 Clutch Actuator Stuck - no sub type information
  • Clutch Actuation Motor fault
Clear DTCs. Cycle ignition, Carry out on demand self test (ODST), record DTCs. Clear DTCs. Cycle ignition. If DTC reoccurs suspect Rear Differential Actuator, refer to the new module installation note at the top of the DTC Index
P2742-00 Transmission Fluid Temperature Sensor B Circuit Low - no sub type information
  • Rear Differential Oil Temperature Sensor short circuit to ground
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Oil Temperature sensor for short circuit to ground
P2743-00 Transmission Fluid Temperature Sensor B Circuit High - no sub type information
  • Rear Differential Oil Temperature Sensor short circuit to power
Refer to the electrical circuit diagrams and check, Rear Differential Actuator - Oil Temperature sensor for short circuit to power or motor circuit
P2785-00 Clutch Actuator Temperature Too High - no sub type information
  • Clutch Actuator Temperature Sensor value above 150 Degrees C
Suspect Rear Differential Actuator, refer to the new component installation note at the top of the DTC Index
P2787-00 Clutch Temperature Too High - no sub type information
  • Rear Differential Clutch Pack temperature value above 200 Degrees C
Suspect mechanical fault with Rear Differential, refer to the new component installation note at the top of the DTC Index
U0001-88 High Speed CAN Communication - Bus off
  • High speed CAN bus off detected
Carry out the CAN network integrity tests using the manufacturer approved diagnostic system
U0100-00 Lost Communication With ECM/PCM "A" - no sub type information
  • Lost Communication With engine control module (ECM) (CAN Bus circuit fault)
Check ECM for stored DTCs. Refer to the electrical circuit diagrams and check Can Bus circuit to ECM for circuit fault
U0121-00 Lost Communication With Anti-Lock Brake System (ABS) Control Module - no sub type information
  • Lost Communication With Anti-Lock Brake System (ABS) Control Module (CAN Bus circuit fault)
Check ABS Control Module for stored DTCs. Refer to the electrical circuit diagrams and check Can Bus circuit to ABS Control Module for circuit fault
U0139-00 Lost Communication With Suspension Control Module "B" - no sub type information
  • Lost Communication With Suspension Control Module "B" (CAN Bus circuit fault)
Check Suspension Control Module "B" for stored DTCs. Refer to the electrical circuit diagrams and check Can Bus circuit to Suspension Control Module "B" for circuit fault
U0155-00 Lost Communication With Instrument Panel Cluster (IPC) Control Module - no sub type information
  • Lost Communication With Instrument Panel Cluster (IPC) Control Module (CAN Bus circuit fault)
Check Instrument Panel Cluster for stored DTCs. Refer to the electrical circuit diagrams and check Can Bus circuit to Instrument Panel Cluster for circuit fault
U0300-00 Internal Control Module Software Incompatibility - no sub type information
  • Wrong Master Config ID received or Signal missing
Incorrect software installed Check/confirm the part number of installed Rear Differential Control Module is correct
U0415-68 Invalid Data Received From Anti-Lock Brake System (ABS) Control Module - event information
  • Invalid data receive
Check Anti-Lock Brake System (ABS) Control Module for stored DTCs
U0422-68 Invalid Data Received From Body Control Module - event information
  • Invalid data receive
Check Body Control Module for stored DTCs
U043A-68 Invalid Data Received From Suspension Control Module "B" - event information
  • Invalid data receive
Check Suspension Control Module "B" for stored DTCs
U0443-68 Invalid Data Received From Body Control Module "B" - event information
  • Invalid data receive
Check Suspension Control Module "B" for stored DTCs for stored DTCs
U1A14-49 CAN Initialization Failure - internal electronic failure
  • Module internal fault
Suspect Rear Differential Control Module, refer to the new module installation note at the top of the DTC Index
P0702-64 Transmission Control System Electrical - signal plausibility failure
  • Implausibility of Motor Temperature Sensor and Oil Sump Temperature Sensor readout detected.
Refer to the electrical circuit diagrams and check, Motor Temperature Sensor and Oil Sump Temperature Sensors and circuit for fault