LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Anti-Lock Control - Stability Assist) >> Anti-Lock Control - Stability Assist >> Removal And Installation >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Refer to Wheel and Tire information.
  3. CAUTION: Make sure that the harness retaining bracket is not removed. Failure to follow this instruction may result in damage to the harness.
    NOTE: Note the orientation of the clip.
  4. See figure
    GJ0025445
  5. CAUTION: Note the fitted position of the component prior to removal.
  6. Torque: 6 Nm
    GJ0023257