LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Anti-Lock Control - Stability Assist) >> Anti-Lock Control - Stability Assist >> Removal And Installation >> Hydraulic Control Unit (HCU) >> Installation

Hydraulic Control Unit (HCU): Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the HCU bracket.
    • Tighten the Torx bolt to 10 Nm (7 lb.ft).
  2. Connect the brake pipe unions.
    • Tighten the brake line unions to 17 Nm (13 lb.ft).
    3. NOTE: When installing the HCU, make sure the locating peg fits securely into the grommet.
  3. Install the HCU and pipe assembly.
    • Position the locating peg.
    • Tighten the Torx bolts to 10 Nm (7 lb.ft).
    • Tighten the brake line unions to 17 Nm (13 lb.ft).
  4. Connect and secure the electrical connector.
  5. Remove the special tool.
  6. Bleed the brake system. Refer to Brake System Bleeding information.
  7. Install the fender splash shield. Refer to Fender Splash Shield information.
  8. Connect the battery ground cable and install the cover. Refer to Specifications information.
  9. Using WDS, configure a new HCU.
scientia non olet · About LEMON Manuals