LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol)) >> Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol) >> Removal And Installation >> Transmission Control Module (TCM) And Main Control Valve Body >> Installation

Transmission Control Module (TCM) And Main Control Valve Body: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
    CAUTION: Install the new seals.
    • Install a new seal block.
      GJ0013889
    2. CAUTION: Install the new seals.
    CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
  2. See figure
    GJ0013888
    3. CAUTION: Make sure the manual park release is correctly engaged.
  3. Torque: 8 Nm
    GJ0013887
    4. CAUTION: Make sure that a new component is installed.
  4. See figure
    GJ0013890
  5. See figure
    GJ0013891
  6. See figure
    GJ0013884
  7. See Transmission Fluid Pan, Gasket and Filter .
  8. Refer to Battery Disconnect and Connect information.
  9. If a new component has been installed, configure using Jaguar approved diagnostic equipment.
scientia non olet · About LEMON Manuals