LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol)) >> Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol) >> Removal And Installation >> Input Shaft Seal >> Removal

Input Shaft Seal: Removal

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to Battery Disconnect and Connect information.
    2. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  2. Raise and support the vehicle.
  3. See Transmission - 3.0L Diesel . .
  4. Holding Pins, Torque Converter (307-613)
    GJ0013877
    5. CAUTION: Take extra care not to damage the edges of the component.
    CAUTION: Discard the seal.
  5. Slide Hammer (100-012)

    Slide Hammer Adaptor (100-012-01)

    Seal Remover Input and Output (308-375)

    GJ0013878
scientia non olet · About LEMON Manuals