LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol)) >> Automatic Transmission/Transaxle (V8 5.0L Petrol/V8 S/C 5.0L Petrol) >> Removal And Installation >> Input Shaft Seal >> Installation

Input Shaft Seal: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Install a new seal.
  1. Front Seal Installer (308-246)
    GJ0013879
    2. NOTE: Make sure that the alignment mark is visible through the inspection hole as illustrated.
  2. Holding Pins, Torque Converter (307-613)
    GJ0013880
    3. CAUTION: Make sure the torque converter is fully located into the oil pump drive.
  3. See figure
    GJ0013881
  4. See Transmission - 3.0L Diesel .
  5. Refer to Battery Disconnect and Connect information.
scientia non olet · About LEMON Manuals