LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Electronic Engine Controls (V8 5.0L Petrol)) >> Electronic Engine Controls (V8 5.0L Petrol) >> Removal And Installation >> Heated Oxygen Sensor (Ho2S) LH >> Installation

Heated Oxygen Sensor (Ho2S) LH: Installation

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the anti-seize compound does not contact the HO2S tip.
    CAUTION: If accidentally dropped or knocked install a new sensor.
    CAUTION: Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
  1. To install, reverse the removal procedure.
    2. NOTE: For NAS vehicles only.
  2. If required, carry out a long drive cycle. Refer to Powertrain Control Module Long Drive Cycle Self-Test information.
scientia non olet · About LEMON Manuals