LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Seating) >> Seating >> Removal And Installation >> Front Seat Backrest Cover >> Installation

Front Seat Backrest Cover: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front seat backrest cover.
    • Install the 16 hog rings.
  2. Secure the front seat backrest cover upper tension straps.
    • Pass through the backrest pad.
    • Attach to the seat frame.
  3. Install the side air bag module.
    • Attach the backrest cover.
    • Tighten the new nuts to 7 Nm (5 lb.ft).
    • Connect the electrical connector.
  4. Secure the front seat backrest cover central tension straps.
    • Attach to the seat frame.
  5. Secure the front seat backrest cover lower retaining clips.
    • Attach to the seat frame.
  6. Secure the front seat backrest cover rear panel retaining clips.
    • Attach to the seat frame.
    • Attach to the backrest cover.
  7. Secure the front seat backrest cover lower tension straps.
    • Attach to the seat frame.
  8. Install the front seat backrest tilt handle trim panel.
    • Install and tighten the Torx screws.
  9. Install the front seat backrest tilt handle.
    • Install the screw.
  10. Install the front seat head restraint guide tube.
    • Release from the seat frame.
    • Secure in the seat frame.
  11. Install the front seat head restraint.
  12. Install the front seat. See Front Seat . .


  1. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals