Pinpoint Test J: Heating And Cooling - Intermittent Operation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- J1: Check For Stored DTC
- Check the Climate Controlled Seat Module for stored DTC's.
Are there any stored DTC's?
YES: For information on stored DTC's refer to the information in the Climate Controlled Seat Module DTC index.
NO: Go to J 2.
- J2: CABLE CONNECTION CHECK WARNING: Before work is carried out, make the air bag supplemental restraint system safe. For additional information, refer to Standard Workshop Practices section of service information.NOTE: The Climate Controlled Seat's (heat and cool) function will only operate when the vehicle's engine is running.NOTE: If a fault is identified and repaired, check for correct operation of the driver and front-passenger climate controlled seat (heat and cool) functions.
- Identify from customer concern or stored DTC's which Seat Climate Assembly is operating intermittently and confirm the harness connector is fully connected.
Is the harness connector is fully connected?
YES: Suspect an internal fault with the Seat Climate Assembly. Replace as required, refer to the Warranty Policy and Procedures manual (section B1.2). Prior to installing a new component.
NO: Disconnect the harness connector, inspect connector and terminals for damage. Repair or replace if required. Reconnect connector and check operation.