LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Seating) >> Seating >> Diagnostic Procedures >> Seats >> Pinpoint Tests >> Pinpoint Test I: Heating And Cooling - Heat Or Cool Operation Slow

Pinpoint Test I: Heating And Cooling - Heat Or Cool Operation Slow

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. I1: Check For Stored DTC 
    1. Check the Climate Controlled Seat Module for stored DTC's.

      2. Are there any stored DTC's? 

      YES:  For information on stored DTC's refer to the information in the Climate Controlled Seat Module DTC index.

      NO:  Go to I 2.

  2. I2: DRIVER OR FRONT PASSENGER SEAT BACKREST CLIMATE ASSEMBLY - FUNCTIONALITY CHECK 
    WARNING: Before work is carried out, make the air bag supplemental restraint system safe. For additional information, refer to Standard Workshop Practices section of service information.
    NOTE: The Climate Controlled Seat's (heat and cool) function will only operate when the vehicle's engine is running.
    NOTE: If a fault is identified and repaired, check for correct operation of the driver and front-passenger climate controlled seat (heat and cool) functions.
    1. Check the heat and cool function of the backrest?

      2. Does the backrest heat and cool function operate correctly? 

      YES:  Go to I 3.

      NO:  Go to I 5.

  3. I3: DRIVER OR FRONT PASSENGER SEAT CUSHION CLIMATE ASSEMBLY - FUNCTIONALITY CHECK 
    1. Check the heat and cool function at the cushion.

      2. Does the cushion heat and cool function operate correctly? 

      YES:  If there are no faults evident, verify the customer concern.

      NO:  Go to I 4.

  4. I4: CUSHION BELLOWS 
    1. Check the condition of the bellows.

      2. Are the bellows obstructed, have they collapsed? 

      YES:  Remove the obstruction or replace collapsed bellows.

      NO:  Go to I 7.

  5. I5: Backrest Bellows Duct 
    1. Check the security of the bellows duct.

      2. Is the bellows duct correctly installed? 

      YES:  Go to I 6.

      NO:  Securely reconnect the bellows duct.

  6. I6: BACKREST BELLOWS 
    1. Check the security of the bellows.

      2. Are the bellows obstructed, have they collapsed? 

      YES:  Remove the obstruction or replace collapsed bellows.

      NO:  Suspect an internal fault with the Seat Climate Assembly. Replace as required, refer to the Warranty Policy and Procedures manual (section B1.2). Prior to installing a new component. Follow the link below to check operation of the Driver or Front Passenger Seat Cushion Climate Assembly. Go to step I 2.

  7. I7: DRIVER OR FRONT PASSENGER SEAT BACKREST CLIMATE ASSEMBLY - OPERATION COMPARISON 
    1. Compare the operation of the suspect climate seat assembly to another climate seat assembly.

      2. Is the operation equal between the two seats? 

      YES:  The operation is standard and comparable to the design intent.

      NO:  Suspect an internal fault with the Seat Climate Assembly. Replace as required, refer to the Warranty Policy and Procedures manual (section B1.2). Prior to installing a new component.

scientia non olet · About LEMON Manuals