Inspection And Verification

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the warranty policy and procedures manual (section B1.2), or determine if any prior approval program is in operation, prior to the installation of a new module/component

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests

NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals

NOTE: The DTC index containing an actions list is for guidance only any reference to "check and install new blower unit" should only be carried out following failure confirmation using the pin out diagnostics and/or the over temperature and fluid/air leak diagnostics contained below. The recording of a DTC does NOT signify a permanently failed unit

NOTE: The climate system functions in a manner that means any detected error state either intermittent or permanent will shut down the complete seat climate system until the next ignition cycle, this does not mean that both climate units within the one seat have failed. This shut down is design intent to protect the system to ensure that the fault detected does not damage the units, it is possible that both units are functioning correctly and that the fault lies elsewhere within the system. The following process can be carried out without removing either the seats or the climate units from the vehicle and should correctly identify any

Verify the customer concern

Visually inspect for obvious signs of mechanical or electrical damage

Visual Inspection

Mechanical	Electrical
Seat heater switch condition and installation	Battery condition and state of charge Fuses Harnesses and connectors Seat heater switch(es) Seat heater elements Seat module(s) Ignition switch Battery junction box Central junction box LIN circuit

If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
If the cause is not visually evident, carry out normal dealer warranty process, perform on-demand self test, check for DTCs and refer to the relevant DTC index
Allow 30 mins since the last seat/cooled operation prior to carrying out pin testing detailed below in the section "Connector and Pin Information"
Locate climate seat module, (refer to Electrical Information - Electrical Reference Library, contained in TOPIx) for guidance on how to gain access to the connector(s)
Locate and disconnect relevant connector prior to pin test
Using ohm-meter to probe each heat/cooled unit pins (at rear of connector), reading should achieve no greater than 10 ohms after 1 minute (initial fluctuations in readings may occur using ohm-meter, post 1 minute readings will have stabilized)