LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Seating) >> Seating >> Diagnostic Procedures >> Seats - Vehicles With: Climate Controlled Seats >> Connector And Pin Information

Connector And Pin Information

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
X150 (All Model Years) 
Terminal ID 
Climate Seat Unit Location  Right Cushion Right Cushion Right Backrest Right Backrest Left Cushion Left Cushion Left Backrest Left Backrest
Wiring Color - Left Hand Drive Vehicles  Y - Yellow BN - Brown R - Red BU-Y - Blue/Yellow G - Green BU - Blue O - Orange WH - White
Wiring Color - Right Hand Drive Vehicles  G - Green BU - Blue O - Orange WH - White Y - Yellow BN - Brown R - Red BU-Y - Blue/Yellow
  1. If any unit reads greater than 10 ohms, replace only that defective unit
  2. If all units read less than 10 ohms but faults are still suspected, do not replace any units. Refer to step 4 below
  3. As a final check, when a faulty unit has been identified strip the seat to access unit connector, REFER to: Seats  and re-check ohm reading to confirm greater than 10 ohms prior to removing unit I
  4. n cases where the above diagnostic routine does NOT identify a failed unit, please refer to "Over Temperature and Fluid/Air Leak Diagnostics" below. Also check for any live technical service bulletins referring to the seat climate system