Component Cleaning
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
To prevent ingress of dirt, accumulations of loose dirt and greasy deposits should be removed before disconnecting or dismantling components or assemblies.
Components should be thoroughly cleaned before inspection prior to reassembly.
Cleaning Methods:
- Dry Cleaning
- Removal of loose dirt with soft or wire brushes
- Scraping dirt off with a piece of metal or wood
- Wiping off with a rag
CAUTION:
Compressed air is sometimes wet so use with caution, especially on hydraulic systems.
- Blowing dirt off with compressed air (Eye protection should be worn when using this method)
- Removal of dry dust using vacuum equipment. This method should always be used to remove friction lining material dust (asbestos particles)
- Steam Cleaning