LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Coupe >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - V8 N/A 5.0L Petrol -- XK/X150 >> Engine - V8 N/A 5.0L Petrol >> Right Cylinder Head >> Removal And Installation >> Removal

Removal And Installation: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect
  2. Raise and support the vehicle.
  3. Refer to: intake Manifold 
  4. Refer to: right Camshaft 
  5. Refer to: Exhaust Manifold
  6. G11285014
  7. G11284988
    8. CAUTION:
    • Discard the seal.
    • LH illustration shown, RH is similar.
    NOTE: Engine shown removed for clarity.
  8. G11284953
  9. G11284955
  10. G11284991
    11. NOTE: Clamp the hose to minimize coolant loss.
  11. G11284956
    12. NOTE: Clamp the hose to minimize coolant loss.
  12. G11284957
  13. G11284958
    14. CAUTION: Discard the seals.
  14. G11284960
  15. G11284996
    16. NOTE: Remove and discard the O-ring seal.
  16. G11284997
    17. NOTE: Discard the gasket.
  17. G11284998
  18. G11284999
    19. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
  19. G11284963
    20. CAUTION: Discard the bolts.
    Fig 1: Cylinder Head Bolt Tightening Sequence
    G11285005Courtesy of OF JAGUAR
  20. NOTE: Discard the gasket.
  21. G11285002
scientia non olet · About LEMON Manuals