Removal And Installation: Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to: Battery Disconnect and Connect
-
Raise and support the vehicle.
- Refer to: Crankshaft Pulley
- Refer to: Engine
- The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
- Make sure that no components fall off during removal.
- Make sure that the crankshaft is not rotated.
- Make sure the crankshaft and flexplate mating faces are clean before installation.
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
- Discard the fuel pipes.
- Be prepared to collect escaping fluids.
- Make sure that all openings are sealed. Use new blanking caps.
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
NOTE:
NOTE:
The high-pressure fuel pumps are removed from the illustration for clarity.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Be prepared to collect escaping fluids.
CAUTION:
Be prepared to collect escaping fluids.
CAUTION:
Be prepared to collect escaping fluids.
CAUTION:
Be prepared to collect escaping fluids.
CAUTION:
Be prepared to collect escaping fluids.
NOTE:
Clean the components general area prior to dismantling.
NOTE:
Discard the component.
NOTE:
Make sure to use the aluminum lug provided on the oil pan extension to lever against.
NOTE:
Do not disassemble further if the component is removed for access only.