Removal And Installation: Removal
CAUTION:
Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE:
Removal steps in this procedure may contain installation details.
-
Refer to: Battery Disconnect and Connect
-
Raise and support the vehicle.
- Refer to: timing Drive Components - Assembly Part Number: Ina Timing Drive or timing Drive Components - Assembly Part Number: Tsubaki Timing Drive
- Rotate the camshafts until all the valves are at their minimum open point.
- Evenly and progressively, release the camshaft bearing caps.
WARNING:
Make sure to support the vehicle with axle stands.
CAUTION:
NOTE:
Remove the camshaft bearing caps.
NOTE:
their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).