Removal And Installation: Installation
Check cylinder head face for distortion, across the center and from corner to corner.
- The head gasket must be installed over the cylinder block dowels.
- Make sure that the mating faces are clean and free of foreign material.
-
Torque Specification: 20 Nm
-
Torque Specification: 35 Nm
-
Tighten the bolts 1 to 10, a further 90 degrees.
-
Tighten the bolts 1 to 10, a further 120 degrees.
Torque Specification: 25 Nm
-
Torque Specification: 12 Nm
- If a new cylinder head has been installed then new tappets must be installed.
- If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
Lubricate the valve tappets with clean engine oil.
Torque Specification: 12 Nm
Torque Specification: 12 Nm
Torque Specification: 10 Nm
Torque Specification: 12 Nm
Torque Specification: 12 Nm
Torque Specification: 20 Nm
Torque Specification: 20 Nm
Torque Specification: 12 Nm
- Refer to: exhaust Manifold Removal And Installation
- Refer to: left Camshaft Removal And Installation
- Refer to: intake Manifold
-
Refer to: Battery Disconnect and Connect
CAUTION:
An acceptable flatness of the cylinder head is 0.1mm.
WARNING:
Make sure care is taken when handling the cylinder head gasket.
CAUTION:
NOTE:
Install a new cylinder head gasket.
CAUTION:
Make sure that new cylinder head bolts are installed.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Tighten the bolts in the indicated sequence.
NOTE:
Tighten the bolts in the indicated sequence.
CAUTION:
CAUTION:
Install the new seals.
NOTE:
Engine shown removed for clarity.
CAUTION:
Install new o-ring seals