Removal And Installation: Installation
- Use only a plastic scraper when removing the sealing material.
- Make sure that the mating faces are clean and free of foreign material.
- Make sure that the Land Rover approved cleaning fluid (Loctite 7063) is used to clean the mating faces.
Apply RTV sealant (Loctite 5901G) in a 2-3mm diameter to the areas shown, and install the engine rear oil seal plate within 7 minutes.
Special Tool(s): 303-1442
Install the special tool.
Special Tool(s): 303-1442
Special Tool(s): 303-1442
Install the bolts and maintain the clearance of 8mm.
Special Tool(s): 303-1442
Remove the special tool.
Special Tool(s): 303-1442
Special Tool(s): JLR-303-1622
-
Using the special tool, install the component.
Special Tool(s): JLR-303-1622
Torque Specification: 11 Nm
Remove the special tool.
Special Tool(s): JLR-303-1622
Torque Specification: 11 Nm
- Refer to: Flexplate
CAUTION:
CAUTION:
Make sure that the Land Rover approved sealant, covers the mating faces of the cylinder block and the oil pan.
CAUTION:
Make sure that the special tool is correctly located.
NOTE:
Install the bolts finger tight.
CAUTION:
Do not fully install the component. Maintain a clearance of 8mm, between the rear oil seal plate and the cylinder block, as smearing of the sealant may occur.
CAUTION:
Apply pressure to the rear oil seal plate in the sequence shown, when installing the special tool.
NOTE:
Tighten the bolts in the indicated sequence.