Removal And Installation: Removal
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
-
Raise and support the vehicle.
- Refer to: Air Deflector
- Refer to: Exhaust System
Torque Specification:
Top nut 40 Nm
Bottom nut 40 Nm
Torque Specification: 48 Nm
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE:
Tighten the top nut first.
NOTE:
If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.