Removal And Installation: Installation

All vehicles 

1. Install the clips.
2. Install the lower trim panel.
   • Tighten the bolts to 6 Nm (4 lb.ft).
3. Install the parking aid sensor.
   • Carefully secure the clips.
   • Repeat the above for the other 3 sensors.
4. Install the bumper insert.
   • Install the clips.
NOTE: Do not disassemble further if the component is removed for access only.

5. Install the wiring harness.

   • Connect and secure the electrical connectors.
   • Carefully secure the clips.
6. Install the tire pressure antenna.
   • Install the clips.
   • Connect the electrical connector.
   • Repeat the above procedure for the other side.
7. With assistance, install the rear bumper cover.
   • Install the bolts and tighten to 6 Nm (4 lb.ft).
   • Install the wiring harness.

   Vehicles with supercharger 

8. Attach the exhaust sound enhancement vacuum pump.
   • Connect the electrical connectors.
   • Tighten the bolt to 7 Nm (5 lb.ft)
   • Secure the wiring harness clip.

   All vehicles 

9. Secure the lower edge of the bumper cover.
NOTE: Align to the position noted on removal.

10. Install the rear lamp assembly.

    • Secure with the clip.
    • Tighten the nuts to 2 Nm (1.5 lb.ft).
    • Connect the electrical connector.
    • Repeat the above procedure for the other side.
11. Install the fender splash shield.
    • Tighten the Torx bolts.
    • Repeat the above procedure for the other side.
12. Install the RH rear quarter trim panel.
    • Install the clip.
13. Install the LH rear quarter trim panel.

    For additional information, refer to: Rear Quarter Trim Panel - 2-Door

14. Install the wheels and tires.

    For additional information, refer to: Wheel and Tire