Removal And Installation: Removal
CAUTION:
Always protect paintwork and glass when removing exterior components.
NOTE:
Removal steps in this procedure may contain installation details.
-
Raise and support the vehicle.
-
Refer to: Wheel and Tire
-
Refer to: Loadspace Trim Panel - 2-Door
-
NOTE:
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 2 Nm
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 7 Nm
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 6 Nm
- LH illustration shown, RH is similar.
- The step must be carried out on both sides.
Torque Specification: 6 Nm
Torque Specification: 6 Nm
- Do not disassemble further if the component is removed for access only.
- RH illustration shown, LH is similar.
- The step must be carried out on both sides.
WARNING:
Make sure to support the vehicle with axle stands.
NOTE:
The procedure must be carried out on both sides.
NOTE:
The procedure must be carried out on both sides.
NOTE:
NOTE:
NOTE:
CAUTION:
Take great care when removing the rear lamp assembly as the forward point of the lens can be easily damaged.
NOTE:
NOTE:
NOTE:
NOTE: