Removal And Installation: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Jaguar XKR-S, 2015 Jaguar XKR, 2014 Jaguar XKR-S, 2014 Jaguar XKR, and 2013 Jaguar XKR-S. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.

NOTE: Removal steps in this procedure may contain installation details.

Refer to: Battery Disconnect and Connect
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: Timing Drive Components - Assembly Part Number: INA Timing Drive or Timing Drive Components - Assembly Part Number: TSUBAKI Timing Drive
CAUTION:
- Rotate the camshafts until all the valves are at their minimum open point.
- Evenly and progressively, release the camshaft bearing caps.

NOTE: Remove the camshaft bearing caps.

NOTE: their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).