LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Engine (V8 5.0L Petrol)) >> Engine (V8 5.0L Petrol) >> Removal And Installation >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

WARNING: This page is about a different car, the 2011 Jaguar XK and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the special tool.

    Rear Crankshaft Seal Installer (303-1442)

    Rear Crankshaft Cover Alignment Tool (303-1443)

    GJ0012812
    2. NOTE: Tighten the bolts in the indicated sequence.
  2. Torque: 11 Nm
    GJ0012813
  3. Torque: 11 Nm
    GJ0012814
  4. Refer to Flexplate .
scientia non olet · About LEMON Manuals