LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Hydraulic Brake Actuation) >> Hydraulic Brake Actuation >> Removal And Installation >> Brake Pedal And Bracket >> Installation

Brake Pedal And Bracket: Installation

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal bracket.
    • Align to the studs and lightly tighten the nuts.
    • Install and tighten the bulkhead screws.
    • Apply sealant to the bulkhead screw heads.
    • Secure the electrical harness with the clip.
  2. Tighten the brake pedal bracket nuts to 25 Nm (18 lb.ft).
  3. Install the plenum chamber panel.
    • Connect the washer jet hose.
    • Carefully secure the clips.
  4. Install the brake master cylinder cover.
    • Carefully secure the clips.
  5. Install the air intake cover.
    • Carefully secure the clips.
  6. Secure the brake booster.
    • Tighten the nuts to 25 Nm (18 lb.ft).
    • Install the brake pedal clevis pin.
  7. Install the brake switch.
  8. Install the throttle pedal assembly.
    • Connect the electrical connector.
    • Install the Torx screws.
  9. Install the windshield wiper arms. Refer to Wiper Pivot Arm information..
  10. Install the instrument panel. Refer to Instrument Panel information..
  11. Connect the battery ground cable and install the cover. Refer to Specifications information.
scientia non olet · About LEMON Manuals