Brake Master Cylinder - (RHD): Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
- Remove the coolant expansion tank. Refer to COOLANT EXPANSION TANK information..
- Remove the brake fluid reservoir. See Brake Fluid Reservoir .
- Release the plenum box sidewall.
- Remove the 4 bolts.
- Remove the coolant expansion tank mounting bracket.
- Remove the 3 nuts.
- Disconnect the brake master cylinder lines.
- Remove the brake master cylinder.
- Remove the 2 nuts.
- Remove and discard the O-ring seal.
NOTE:
Some fluid spillage is inevitable during this operation.
CAUTION:
Before disconnecting or removing the components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.