Brake Master Cylinder - (RHD): Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new O-ring seal.
- Install the brake master cylinder.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Connect the brake master cylinder lines.
- Tighten the brake line unions to 17 Nm (13 lb.ft).
- Install the plenum chamber panel.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Install the coolant expansion tank mounting bracket.
- Tighten the nuts to 10 Nm (7 lb.ft).
- Remove the brake fluid reservoir. See Brake Fluid Reservoir .
- Install the coolant expansion tank. Refer to COOLANT EXPANSION TANK information..