Brake Master Cylinder - (LHD): Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new O-ring seal.
- Install the brake master cylinder.
- Tighten the nuts to 25 Nm (18 lb.ft).
- Connect the brake master cylinder lines.
- Tighten the brake line unions to 17 Nm (13 lb.ft).
- Connect and secure the electrical connector.
- Tighten the bolt.
- Install the brake fluid reservoir. See Brake Fluid Reservoir .