Brake Fluid Reservoir: Installation
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the components.
- Install the brake fluid reservoir.
- Install new brake fluid reservoir seals.
- Tighten the Torx bolt to 6 Nm (4 lb.ft).
- Connect the low brake fluid warning indicator switch electrical connector.
- Bleed the brake system. Refer to Brake System Bleeding information..
- Install the air intake cover.
- Carefully secure the clips.