Customer Programmable Security Features

WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.

A number of security features can be programmed to the customers requirements by use of the TSD.

Global Open/Close

The global open/ close feature allows the driver to fully raise/lower the driver and passenger windows with a single press of a smart key button. The button must be pressed and held for more than 2 seconds. Either or both of the open/close functions can be disabled from the TSD.

NOTE: Remote global close is not available in all markets.

From the Home screen, select the Vehicle screen and select Veh. Settings. The Security button will be highlighted as the default selection. Scroll the screen until the Global Open and Global Close selections are displayed. Global open and/or global close can be switched on or off by touching the applicable button on the TSD.

Valet Mode

Valet mode allows unlocking of the liftgate to be inhibited. When in valet mode, if either the switch pack or exterior luggage compartment release button is pressed, an audible warning chime is emitted to warn that the liftgate is inhibited.

Enabling Valet Mode

Using the emergency key from the smart key, lock the glovebox. From the Home screen, select the Valet button. The valet mode screen is displayed and requires a four digit PIN (personal identification number) for access. Enter the PIN using the digits on the TSD and press OK. When the PIN is accepted the screen displays Valet On. The glovebox and the liftgate are now locked in valet mode. On leaving the vehicle, only give the attendant the smart key without the emergency key installed.

Disabling Valet Mode

After entering the vehicle, access the valet mode screen, enter the four digit PIN number and touch the OK button. When the PIN is accepted, the screen displays Valet Off. Unlock the glovebox using the emergency key and replace the emergency key in the stowage slot in the smart key.

Single Point Entry

The single point entry feature only unlocks one door, all other panels remain locked.

On vehicles with the remote CLS, a single press of the unlock button on the smart key unlocks only the driver's door. A second press will unlock the passenger door and the liftgate.

On vehicles with the passive entry system, the first door handle which is pulled will only open that door to gain access to the vehicle. The remaining door and the liftgate will revert to central locking. The locked door can be unlocked by operating the interior door release lever and the liftgate can be released using the liftgate release button in the auxiliary lighting switch, the smart key liftgate release button or the exterior liftgate release button.

From the Home screen, select the Vehicle screen and select Veh. Settings. The Security button is highlighted by default. Select 2 stage unlock and touch the on or off button to enable or disable the single point entry feature.

Changing from central locking to single point entry and back again can also be carried out by pressing the lock and unlock buttons on the smart key simultaneously. The turn signal indicators will flash after 4 seconds to confirm that the change has been performed.

Drive Away Locking

The drive away door locking feature locks the doors and the liftgate if they are unlocked when the transmission selector lever is not in P and the vehicle speed is more than 7 km/h (5 mph).

From the Home screen, select the Vehicle screen and select Veh. Settings. The Security button is highlighted by default. Scroll the screen until the Drive away locking section is displayed. Select the drive away locking feature on or off by touching the applicable button on the TSD.