Coolant Pump - V8 S/C 5.0L Petrol: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Refer to Battery Disconnect and Connect information.
- Raise and support the vehicle.
- Refer to Engine Cover - 5.0L information.
- Refer to Cooling System Draining and Vacuum Filling information.
- Refer to Supercharger Belt information.
- See figure
- See figure
- Torque: 40 Nm
- See figure
- Torque: 12 Nm
- See figure
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Make sure that the accessory drive belt is correctly located on each pulley.
CAUTION:
Clean and inspect the accessory drive belt pulleys for damage.
WARNING:
Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.
CAUTION:
Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
CAUTION:
Note the fitted position of the component prior to removal.