Catalytic Converter RH: Removal
WARNING: This page is about a different car, the 2011 Jaguar XKR, 2011 Jaguar XK, 2010 Jaguar XKR, and 2010 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Raise and support the vehicle.
- Refer to Air Deflector information.
- Refer to Exhaust System .
- See figure
- See figure
- Torque:
Top nut 40 Nm
Bottom nut 40 Nm
- Torque: 48 Nm
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE:
Tighten the top nut first.
NOTE:
If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.