Removal And Installation: Removal

1. Remove the cover and disconnect the battery ground cable.

   For additional information, refer to: Battery Disconnect And Connect

2. Make the SRS system safe.

   For additional information, refer to: Supplemental Restraint System (SRS) Depowering and Repowering .

3. Remove the LH roll over protection unit.

   For additional information, refer to: Rollover Protection Unit

4. Remove the rear seat RH backrest retaining bracket.

   • Remove the 2 nuts and 2 bolts.

5. Remove the RH roll over protection unit.

   • Disconnect the electrical connector.
   • Remove the 4 Torx bolts.

6. Release the auxiliary junction box mounting bracket.

   • Remove the 3 nuts.

Remove the parking brake module.

• Remove the 3 nuts.
• Disconnect the 2 electrical connectors.