LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake & Actuation - Vehicles W/O Carbon Ceramic Brakes -- XK/X150 >> Parking Brake And Actuation >> Parking Brake Module - Convertible >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Install the parking brake module.
    • Tighten the nuts to 4 Nm (3 lb.ft).
    • Connect the electrical connectors.
  2. Secure the auxiliary junction box mounting bracket.
    • Tighten the nuts to 10 Nm (7 lb.ft).
  3. Install the rear seat RH backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  4. Install the RH roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  5. Install the LH roll over protection unit.

    For additional information, refer to: Rollover Protection Unit

  6. Connect the battery ground cable and install the cover.

    For additional information, refer to: Battery Disconnect And Connect

  7. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals