Hydraulic Control Unit
The HCU has three operating modes:
- Normal braking/EBD (electronic brake force distribution)
- ABS braking
- Active braking.
Normal Braking/EBD
Initially, all of the solenoid-operated valves are de-energized. Operating the brake pedal produces a corresponding increase or decrease of pressure in the brakes, through the open pilot valves and inlet valves. If the ABS module determines that EBD is necessary, it energizes the inlet valves for both rear brakes, to isolate the brakes from any further increase in hydraulic pressure.
ABS Braking
If the ABS module determines that ABS braking is necessary, it energizes the inlet and outlet valves of the related brake and starts the return pump. The inlet valve closes to isolate the brake from pressurized fluid; the outlet valve opens to release pressure from the brake into the accumulator, and the inlet side of the return pump. The reduced hydraulic pressure allows the wheel to accelerate. The ABS module then operates the inlet and outlet valves to modulate the pressure in the brake to apply the maximum braking effort without locking the wheel. Control of the valves for each wheel takes place individually.
Active Braking Mode
The active braking mode is used to generate and control hydraulic pressure to the brakes for functions other than normal braking/EBD and ABS braking, i.e. DSC (dynamic stability control), CBC (corner brake control), ETC (electronic traction control), EBA (emergency brake assist), understeer control and electronic brake prefill (on vehicles with ASC (adaptive speed control)).
For additional information, refer to: Anti-Lock Control - Stability Assist - 5.0L (Description and Operation).
For active braking, the ABS module energizes the pilot valves and priming valves, starts the return pump and energizes the inlet valves and outlet valves when required. Brake fluid, drawn from the reservoir through the master cylinder and priming valve, is pressurized by the return pump and supplied to the inlet valves. The ABS module then operates the inlet valves and outlet valves, as required, to modulate the pressure in the individual brakes. Some noise may be generated during active braking.