Removal And Installation: Installation

1. Install the brake pedal bracket.
   • Align to the studs and lightly tighten the nuts.
   • Install and tighten the bulkhead screws.
   • Apply sealant to the bulkhead screw heads.
   • Secure the electrical harness with the clip.
2. Tighten the brake pedal bracket nuts to 25 Nm (18 lb.ft).
3. Install the plenum chamber panel.
   • Connect the washer jet hose.
   • Carefully secure the clips.
4. Install the brake master cylinder cover.
   • Carefully secure the clips.
5. Install the air intake cover.
   • Carefully secure the clips.
6. Secure the brake booster.
   • Tighten the nuts to 25 Nm (18 lb.ft).
   • Install the brake pedal clevis pin.
7. Install the brake switch.
8. Install the throttle pedal assembly.
   • Connect the electrical connector.
   • Install the Torx screws.
9. Install the windshield wiper arms.

   For additional information, refer to: Wiper Pivot Arm (Removal and Installation).

10. Install the instrument panel.

    For additional information, refer to: Instrument Panel (Removal and Installation).

11. Connect the battery ground cable and install the cover.

For additional information, refer to: Battery, Mounting And Cables -- XK/X150 (Specifications)