LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Front Disc Brake - Vehicles W/O Carbon Ceramic Brakes -- XK/X150 >> Front Disc Brake >> Brake Caliper - Vehicles With: High Performance Brakes (G1073730) >> Removal And Installation >> Removal

Removal And Installation: Removal

CAUTION: Brake fluid will damage paint finished surfaces. If spilled, immediately remove the fluid and clean the area with water.
NOTE: Removal steps in this procedure may contain installation details.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Remove the left-hand front wheel and tire.

    Refer to: Wheel and Tire (Removal and Installation).

  3. G11284385
  4. CAUTION: Always plug any open connections to prevent contamination.
  5. NOTE:
    • To prevent the loss of brake fluid, using the special tool apply the brake pedal and set to 40mm (1.6 in) below the rest position.
    • Left-hand shown, right-hand similar.
    • Remove and discard the two sealing washers.
    G11284386
  6. NOTE: Left-hand shown, right-hand similar.
    G11284387
  7. G11284388
  8. CAUTION: Removal of the clips is a delicate procedure, damage will occur if any force is used.
    NOTE: Left-hand shown, right-hand similar.
    G11284389
    • Lever the anti-rattle spring in the center of the spring until either side is released.
  9. WARNING: If the brake caliper piston seal is damaged a new brake caliper must be installed.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    NOTE: Left-hand shown, right-hand similar.
    G11284390
  10. NOTE: Left-hand shown, right-hand similar.
    G11284391
    • Release the clip.
  11. NOTE: Left-hand shown, right-hand similar.
    G11284392
scientia non olet · About LEMON Manuals