LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XJR Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Fuel Charging & Controls - V8 S/C 5.0L Petrol -- XJ/X351 >> Fuel Charging And Controls - V8 S/C 5.0 L Petrol >> Removal And Installation >> Fuel Rail LH (G1280005) >> Removal

Fuel Rail LH (G1280005): Removal

CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE:
  • Removal steps in this procedure may contain installation details.
  • Some variation in the illustrations may occur, but the essential information is always correct.
  1. Refer to: PETROL AND PETROL-ETHANOL HEALTH AND SAFETY PRECAUTIONS .
  2. Refer to: FUEL SYSTEM PRESSURE RELEASE - GTDI 2.0L PETROL/V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829) .
  3. Refer to: BATTERY DISCONNECT AND CONNECT .
  4. Refer to: ENGINE COVER - V8 5.0L PETROL/V8 S/C 5.0L PETROL .
  5. Refer to: Secondary Bulkhead Panel LH .
  6. Refer to: FUEL INJECTION COMPONENT CLEANING .
  7. CAUTION: Be prepared to collect escaping fluids.
    G11288194
  8. G11288195
  9. CAUTION: Be prepared to collect escaping fluids.
    G11288196
  10. CAUTION: Be prepared to collect escaping fluids.
    G11288197
  11. CAUTION: Be prepared to collect escaping fluids.
    G11288198
  12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    G11286716
  13. G11288037
  14. G11288038
  15. NOTE: RH shown LH similar.
    G11288039

    Special Tool(s):  303-1450

  16. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
    G11288040
  17. CAUTION:
    • Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    • Make sure that the special tool is held square to the fuel injector during removal.
    • Make sure that all open ports are covered to prevent any foreign material ingress.
    G11288041

    Special Tool(s):  310-197

  18. CAUTION:
    • If new fuel injectors are installed, a new injector clamp must be installed.
    • If the fuel injector is being removed without a new component being installed, the fuel injector clamp must remain with the fuel injector it is removed with.
    G11288042
  19. CAUTION:
    • Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    • Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
    • Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
    G11288043
  20. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
    G11288044
scientia non olet · About LEMON Manuals