LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2014 >> XFR >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Fuel Tank & Lines (V8 4.2L Petrol/V8 S/C 4.2L Petrol)) >> Fuel Tank And Lines (V8 4.2L Petrol/V8 S/C 4.2L Petrol) >> Removal And Installation >> Fuel Pump And Sender Unit >> Removal

Fuel Pump And Sender Unit: Removal

WARNING: This page is about a different car, the 2010 Jaguar XF and 2009 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Refer to: FUEL SYSTEM PRESSURE RELEASE - V6 S/C 3.0L PETROL/V8 5.0L PETROL/V8 S/C 5.0L PETROL (G1084829)
  3. See figure
    GJ0011179
  4. See figure
    GJ0022957
  5. See figure
    GJ0022958
  6. See figure
    GJ0022959
  7. See figure
    GJ0022960
    • Locking Ring, Fuel Tank (310-123)
      GJ0022961
    9. NOTE: Note the position of the locating tang.
    NOTE: Remove and discard the O-ring seal.
  9. See figure
    GJ0022962
    10. CAUTION: Take extra care not to damage the fuel tank level sensor float and arm.
  10. See figure
    GJ0022963
scientia non olet · About LEMON Manuals