Fuel Tank
| Item Number | Description |
|---|---|
| 1 | Fuel filler pipe connection and spit back flap |
| 2 | fuel pump driver module (FPDM) |
| 3 | DMTL Pump |
| 4 | EVAP hose |
| 5 | Hose - EVAP charcoal canister to purge valve |
| 6 | Vapor pressure control valve |
| 7 | Hose connection - EVAP charcoal canister to purge valve |
| 8 | Fuel supply to engine |
| 9 | left-hand (LH) fuel level sensor float |
| 10 | left-hand (LH) fuel level sensor |
| 11 | Liquid Vapor Separator (LVS) |
| 12 | Fuel delivery pump outlet connection |
| 13 | right-hand (RH) fuel level sensor float |
| 14 | right-hand (RH) fuel level sensor |
| 15 | Fuel pump module |
The fuel tank is a saddle type tank, blow molded from HDPE (high density polyethylene). The tank is located forward of the rear suspension and is mounted using two metal straps. The tank is a sealed unit with the only internal access being through the fuel pump module aperture on the top of the tank.
The fuel pump module flange has a six pin external connector which provides the electrical connections for the fuel pump and both fuel level sensors. A quick release connector provides for the connection of the fuel feed pipe.
The flange is fitted with a locking ring and seal. The seal locates in a groove on the tank. The locking ring locates and clamps on the encapsulated ring that is molded into the fuel tank. The flange has a tag which locates in the top of the tank to ensure correct orientation.
A carrier within the tank provides for the mounting of the passive side jet pump, vent valve, ROV and liquid vapor separator (LVS), level sensors and passive side drain.