LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine - V8 N/A 5.0L Petrol -- XK/X150) >> Engine - V8 N/A 5.0L Petrol >> Timing Cover >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure that the mating faces are clean and free of foreign material.
  1. G11285242
    • Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
  2. CAUTION: Make sure that the mating faces are clean and free of foreign material.
  3. G11285243
    • Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.
  4. NOTE: Tighten the bolts in the indicated sequence.
    Fig 1: Upper Timing Cover Bolts Tightening Sequence
    GJ0012157Courtesy of OF JAGUAR
    Fig 2: Upper Timing Cover Bolts Tightening Sequence
    GJ0012157Courtesy of OF JAGUAR
  5. Torque Specification: 12 Nm 

  6. NOTE: Tighten the bolts in the indicated sequence.
    Fig 3: Upper Timing Cover Bolts Tightening Sequence
    G11540843Courtesy of OF JAGUAR
  7. Torque Specification: 12 Nm 

  8. G11285177

    Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.

  9. CAUTION: Make sure that the mating faces are clean and free of foreign material.
  10. G11285178

    Install the bolts, but do not tighten fully at this stage.

    Special Tool(s):  303-1433

  11. NOTE: Tighten the bolts in the indicated sequence.
    Fig 4: Lower Timing Cover Bolts Tightening Sequence
    G11285180Courtesy of OF JAGUAR
  12. Torque Specifications: 

    M6 12 Nm 

    M8 20 Nm 

  13. G11540847

    Torque Specification: 12 Nm 

  14. G11285240

    Torque Specification: 12 Nm 

  15. G11285239

    Torque Specification: 12 Nm 

  16. G11285356

    Torque Specification: 40 Nm 

  17. NOTE: Install the bolt finger tight before final tightening.
    G11285355

    Torque Specification: 40 Nm 

  18. Refer to: Crankshaft Pulley 
  19. Refer to: Valve Cover RH 
  20. Refer to: Valve Cover LH 
  21. Refer to: Thermostat Housing - V8 5.0L Petrol
  22. Refer to: Accessory Drive Belt - V8 5.0L Petrol
  23. Refer to: Battery Disconnect and Connect