LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine - V8 N/A 5.0L Petrol -- XK/X150) >> Engine - V8 N/A 5.0L Petrol >> Oil Pan Extension >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect
    2. WARNING: Make sure to support the vehicle with axle stands.

  2. Raise and support the vehicle.

  3. Refer to: Crankshaft Pulley
  4. Refer to: Engine 
    5. CAUTION:
    • The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
    • Make sure that no components fall off during removal.
    NOTE:
    • Make sure that the crankshaft is not rotated.
    • Make sure the crankshaft and flexplate mating faces are clean before installation.
  5. G11285085
  6. Fig 1: Generator Bolt Tightening Sequence
    G11285143Courtesy of OF JAGUAR
  7. G11285144
  8. G11292984
  9. G11285147
  10. G11285356
  11. G11285355
  12. G11285150
    13. NOTE: The high-pressure fuel pumps are removed from the illustration for clarity.
  13. G11286770
    14. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
  14. G11285092
  15. G11285152
    16. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
  16. G11285153
  17. G11284999
  18. G11508106
  19. G11285201
    20. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    • Discard the fuel pipes.
  20. G11285157
    21. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
  21. G11288126
  22. G11293608
    23. CAUTION: Be prepared to collect escaping fluids.
  23. G11285187
    24. CAUTION: Be prepared to collect escaping fluids.
  24. G11285160
  25. G11508113
    26. CAUTION: Be prepared to collect escaping fluids.
  26. G11285190
    27. CAUTION: Be prepared to collect escaping fluids.
  27. G11285161
    28. CAUTION: Be prepared to collect escaping fluids.
  28. G11285164
  29. G11285136
  30. G11285166
    31. NOTE: Clean the components general area prior to dismantling.
  31. G11284855
    32. NOTE: Discard the component.
  32. G11285168
  33. G11285169
    34. NOTE: Make sure to use the aluminum lug provided on the oil pan extension to lever against.
  34. G11285170
    35. NOTE: Do not disassemble further if the component is removed for access only.
  35. G11285171
scientia non olet · About LEMON Manuals