Removal And Installation: Installation

All vehicles 

1. Torque Specification: 45 Nm 

NOTE: Install a new gasket.

2. Install the special tool.

   Special Tool(s):  303-1444-01, 303-1444-02

NOTE: If a new cylinder head is installed use the special tools in the illustration.

3. Install the special tool.

   Special Tool(s):  303-1444-02

CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.

4. Torque Specification: 10 Nm 

5. Remove the special tool.

CAUTION: Make sure that new bolts are installed.
NOTE: Install the spacers in the noted position.

6. Torque Specification: 10 Nm 

7. Fig 1: Exhaust Manifold Bolt Tightening Sequence

   Courtesy of OF JAGUAR

   Torque Specification: 18 Nm 

9. Refer to: Catalytic Converter

10. Left-hand drive vehicles 

11. Torque Specification: 100 Nm 

WARNING: Make sure that a new bolt is installed.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

12. Torque Specification: 35 Nm 

    All vehicles 

13. Torque Specification: 25 Nm 

14. Torque Specification: 25 Nm 

15. Torque Specification: 10 Nm 

16. Torque Specification: 10 Nm 

17. Torque Specification: 25 Nm 

18. Torque Specification: 3 Nm 

19. Torque Specification: 3 Nm 

20. Refer to: Power Steering Pump
21. Refer to: Battery Disconnect and Connect