LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine - V8 N/A 5.0L Petrol -- XK/X150) >> Engine - V8 N/A 5.0L Petrol >> Engine Oil Vacuum Draining And Filling >> General Procedures >> Special Tool(S) >> Draining

Special Tool(S): Draining

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The spilling of hot engine oil is unavoidable during this procedure, care must be taken to prevent scalding.
CAUTION: Correct installation of the oil filler cap can be obtained by tightening the cap until hard stop.
NOTE:
  • Make sure that the vehicle is parked on level ground.
  • Clean the components general area prior to dismantling.
  1. Start the engine and allow to run for 10 minutes, stop the engine.
    2. CAUTION: Allow 10 minutes from turning the engine off before starting oil extraction.
  2. G11284811
  3. Refer to: Engine Cover - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133
  4. G11284812
    • Loosen the element cover 4 complete turns to allow engine oil to drain from the filter cover.
  5. G11284835
    • Using the oil vacuum pump drain the oil out through the oil extraction tube.

      Special Tool(s):  303-1484, 303-1484-01

    • Remove the oil vacuum pump.
  7. G11284813
    8. NOTE: Discard the O-ring seals.
  8. G11284814

    FILLING 

    9. NOTE: Install new O-ring seals.
  9. G11284817

    Lubricate the oil filter element O-ring seal with clean engine oil.

    10. CAUTION: Tighten the component finger tight first.
  10. G11284818
    • Torque Specification: 25 Nm 
    11. CAUTION: Make sure that the vehicle is left for 5 minutes from filling with oil and that the engine oil level is reading at least minimum (by following Steps  7- 11), before starting the engine.
    • Fill the engine with oil - for filling values on vehicles without supercharger:

      Refer to: Specifications

    • Fill the engine with oil - for filling values on vehicles with supercharger:

      Refer to: Specifications 

    • Clean any residual engine oil from the oil filler cap area.
  12. G11284819
    13. CAUTION: Make sure that the vehicle has been left for 5 minutes from filling with oil.

  13. Follow the Steps  7- 11 before starting the engine.

    • Start the engine and allow to run for 10 minutes, stop the engine.
    • Check for leaks.
    15. CAUTION:
    • Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
    • Make sure that the hood is open.
    • Turn the ignition on.
  16. G11507812
    • Scroll through the trip menu to access the engine oil level display.
  17. G11507813
    • Press the cruise control cancel button twice within 2 seconds.
  18. G11507814
    • The message center display will revert to the normal display in the trip computer.
    • Scroll through the trip menu to access the engine oil level display.
    • Check that the oil level display shows an oil level reading.
    • Only after having started and run the engine for 10 minutes (as indicated in Step  6), switch off the engine, then stabilizing for 10 minutes, take a reading from the oil level display and, if necessary top up with engine oil.
    19. NOTE: If instructed to follow Steps  7- 11 in a previous step, return to Step  6 and continue the procedure.

  19. Turn the ignition off.

  20. Allow 10 minutes for the engine oil level to stabilize if there has been additional oil top up.
    21. NOTE: The following steps are to update the average oil level value.
  21. G11507813
    • Turn the ignition on.
    • Press and hold the cruise control cancel button for more than 2 seconds.
  22. The message center display will revert to the normal display in the trip computer.
  23. Turn the ignition off.
  24. Turn the ignition on.
  25. G11507814
    • Scroll through the trip menu to access the engine oil level display.
    • Make sure that the average oil level value has now been updated.
  26. Refer to: Engine Cover - 5.0L NA V8 - AJ133/5.0L SC V8 - AJ133
scientia non olet · About LEMON Manuals