LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine - V8 N/A 5.0L Petrol -- XK/X150) >> Engine - V8 N/A 5.0L Petrol >> Cylinder Head >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Battery Disconnect and Connect
    2. WARNING: Make sure to support the vehicle with axle stands.

  2. Raise and support the vehicle.

  3. Refer to: left Camshaft Removal And Installation 
  4. Refer to: exhaust Manifold Removal And Installation 
  5. Refer to: intake Manifold 
  6. G11284951
  7. G11284952
  8. CAUTION: Discard the seal.
    NOTE: Engine shown removed for clarity.
    G11284953
  9. G11284954
  10. G11284955
  11. NOTE: Clamp the hose to minimize coolant loss.
    G11284956
  12. NOTE: Clamp the hose to minimize coolant loss.
    G11284957
  13. G11284958
  14. G11285762
  15. G11284959
  16. CAUTION: Discard the seals.
    G11284960
  17. G11284961
  18. G11284962
    19. CAUTION:
    • If a new cylinder head has been installed then new tappets must be installed.
    • If the cylinder head is being removed without a new component being installed, the tappets must be installed in their original positions.
    NOTE: Left-hand shown, right-hand similar.
  19. G11284963
    20. CAUTION: Discard the bolts.
  20. G11284964
    21. NOTE: Discard the gasket.
  21. G11284965
scientia non olet · About LEMON Manuals