LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2012 >> XKR 2D Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Fuel Charging & Controls - V8 N/A 5.0L Petrol -- XK/X150) >> Fuel Charging And Controls - V8 N/A 5.0L Petrol >> Left Fuel Rail >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2015 Jaguar XK, 2014 Jaguar XK, 2013 Jaguar XK, and 2012 Jaguar XK. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure that tools and equipment are clean, free of foreign material and lubricant.
NOTE: Removal steps in this procedure may contain installation details.
  1. Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions
  2. Refer to: Fuel System Pressure Release - V8 5.0L Petrol/V8 S/C 5.0L Petrol
  3. Refer to: Battery Disconnect and Connect
  4. Refer to: Fuel Injection Component Cleaning
  5. Refer to: Cowl Vent Screen
  6. G11508542

    Torque Specification: 45 Nm 

  7. G11541488
  8. G11288033
    9. CAUTION: Be prepared to collect escaping fluids.
  9. G11288034
  10. G11285512
  11. Refer to: Air Cleaner Outlet Intermediate Pipe RH
    12. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
  12. G11285092
  13. G11285152
    14. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
  14. G11285153
    15. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

  15. Raise and support the vehicle.

    16. NOTE: Engine shown removed for clarity.
  16. G11285155
    17. NOTE: Engine shown removed for clarity.
  17. G11285201
    18. CAUTION:
    • Be prepared to collect escaping fluids.
    • Make sure that all openings are sealed. Use new blanking caps.
    NOTE: Engine shown removed for clarity.
  18. G11285157
  19. Lower the vehicle.
  20. G11288037
  21. G11288038
  22. NOTE: RH shown LH similar.
    G11288039

    Special Tool(s):  303-1450

    23. CAUTION: Make a note of the fuel injector clamp alignment to the fuel rail prior to removal.
  23. G11288040
    24. CAUTION:
    • Make sure that the special tool is located correctly to the fuel injector prior to removing the fuel injector.
    • Make sure that the special tool is held square to the fuel injector during removal.
    • Make sure that all open ports are covered to prevent any foreign material ingress.
  24. G11288041

    Special Tool(s):  310-197

    25. CAUTION: If the fuel injector is being removed without a new component being installed, the fuel injector clamp must remain with the fuel injector it is removed with.
  25. G11288042
    26. CAUTION:
    • Do not use a knife to remove the Teflon seal as damage could occur to the fuel injector.
    • Do not cut the Teflon seal to deep as damage could occur to the fuel injector.
    • Pinch the Teflon seal to allow the tool to cut the Teflon seal without damaging the fuel injector.
  26. G11288043
    27. CAUTION: Do not use any sharp tools to remove the O-ring seal as damage could occur to the fuel injector.
  27. G11288044
scientia non olet · About LEMON Manuals